|
|
|||||||
| Die-Cast Conversions Tech. The tricks of installing drive line and electrical components into die-cast models. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
09-07-2013, 11:31 AM
|
||||
|
||||
Re: He is at it again! 1:50 Dozer Conversion
Jim, I was searching for stuff on the forum and found this thread, didn't know if you've seen it, check out the first post!
http://www.rctruckandconstruction.co...e+truck+forums. 
|
|
#2
09-07-2013, 03:23 PM
|
||||
|
||||
|
Re: He is at it again! 1:50 Dozer Conversion
Ya, I had seen the video once before. The more I work with the ginger stuff, the more I like it. And the 1/16 STILL seems small even after working on some 1:50 stuff!
Here is the latest video of my 1:16 dozer. I have switched over to gear motors for the drives. I'm installing a wedge now to hold the motor and pinion up against the crown gears. I am still searching for replacement crown gears. I'm using the blue slot.it crowns now I think they are 24 or 26 tooth,but the plastic is not going to hold up. http://youtu.be/1VZZfcgRaB4 Jim
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
