|
|
|||||||
| Die-Cast Conversions Tech. The tricks of installing drive line and electrical components into die-cast models. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
09-27-2013, 05:33 PM
|
||||
|
||||
Re: He is at it again! 1:50 Dozer Conversion
I'm not totally sure about the time but I estimate 4 or 5 hours. The nubs cast on the inner part poked into the hole of the outer tread in front of it. They were never that tight to start with.
Jim 
|
|
#2
09-27-2013, 06:50 PM
|
||||
|
||||
|
Roller chain with tabs for track pads?
What/where should I look for roller chain with mounting tabs for building tracks if it comes to that?
If I understand and measured correctly, the original tracks measure 3/8" pin to pin. And 1/8" wide inside. Jim
|
|
| Currently Active Users Viewing This Thread: 4 (0 members and 4 guests) | |
|
|
Hybrid Mode
