379ex Hood Tri Axle Pete

[Tamiya Cowboy]

Well while I was in Indy I fell head over heals for a rig and when I found out it was for sale I had to have it! Thanks ED.




now I am not going to change much on this truck I will be putting a cat under the hood and putting low pros on the lift axle but other than that I am just going to redo the side of the hood so it is all one piece and that way it will also have the 1 inch ext in front of the steps so I can put lights in that spot to. I will also do super singles on the front I picked up some other parts from Ric and I ordered RC4WD punisher drive shaft for this truck and the hay hauler today you can get them in any lenght you just have to ask.

So the list looks like this

55 Turn 6 tooth pnion
GD600 gear reduction
MFU
PMD blank with lights
robbe low pro tires
cat die cast motor and rad under the hood
hidden servo for 5th wheel
custom rear light bar
Super singles
PMD blank with lights
RC4WD punisher drive shaft
And lots of LEDs.

and a few other odds and ends.