|
Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Re: CAT 14M3 Motor Grader
There's couple of reasons, it was very fun project at the first time (or have I just forget all the not so fun parts) and I think I can make some areas better. Also there's not too many grader projects going on over here.
__________________
Ari To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#2
|
|||
|
|||
Re: CAT 14M3 Motor Grader
Quote:
Will be good to follow this one! |
#3
|
|||
|
|||
Re: CAT 14M3 Motor Grader
Great work and a lot of attention to detail as usual for you keep up the great work. Ed
|
#4
|
||||
|
||||
Re: CAT 14M3 Motor Grader
Hi
Its great to see another excellent build starting to take shape in your workshop. looking forward to enjoying this build progressing. many thanks for sharing with us all.
__________________
Regards Mark Over the Pond in the UK Member of Ribble Valley Radio Controlled Truck Club my weather station To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#5
|
|||
|
|||
Re: CAT 14M3 Motor Grader
__________________
Ari To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#6
|
|||
|
|||
Re: CAT 14M3 Motor Grader
I got to the mill today, but it did not go quite as planned
The front frame is so long that i had to disable my limit switches on x-axis to get every millimeter in use. I of course at the other end my table hit the end and lost some steps. I did not noticed that right away but when I did, it was game over The pocket was machined from two directions, and the left one wen't well, but on the right it lost the steps and the pockets did not quite meet
__________________
Ari To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#7
|
|||
|
|||
Re: CAT 14M3 Motor Grader
__________________
Ari To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|