|
|
|||||||
| General Discussion A place to post off topic discussions. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
03-02-2017, 12:33 AM
|
|||
|
|||
3D printed utility vehicle
If you haven't seen this yet, what a cool vehicle. Think around $2000 for RTR as in the video Medic just did on it or you can go the kit route for a bit less. Would like to see what kind of weight the bucket can handle.
https://www.youtube.com/watch?v=Dx7zCoZgdPU https://spykerworkshop.com/shop/comp...at/#spyker-kat Last edited by TheBennyB; 03-02-2017 at 12:38 AM. 
|
|
#2
03-12-2017, 09:42 PM
|
||||
|
||||
Re: 3D printed utility vehicle
|
|
#3
03-18-2017, 02:44 AM
|
||||
|
||||
Re: 3D printed utility vehicle
Had an idea...would be pretty cool to have an adapter made to fit Spyker's snowblower to Eagle's 870k loader. Think it would look pretty sick and make quick work of clearing the walkway
|
|
#4
03-21-2017, 10:06 AM
|
|||
|
|||
|
Re: 3D printed utility vehicle
I have the spyker snowblower on a RC truck and that thing works great! I run a brushless motor on it and I have cleared my entire 120' driveway with it a few times. It will throw snow much farther than the width of the driveway too. Not sure its wide enough to cover the track width of a loader, but it would not be hard to make custom mounts for it to fit. Thats the beauty of 3d printing tho is that it would not be terribly difficult to make the whole snowblower wider I wouldnt think.
|
|
#5
03-21-2017, 10:18 AM
|
||||
|
||||
|
Re: 3D printed utility vehicle
That's awesome
|
|
#7
03-21-2017, 11:08 PM
|
||||
|
||||
|
Re: 3D printed utility vehicle
Get something like this going only in 1:14
 
|
|
#8
10-15-2017, 09:24 PM
|
||||
|
||||
|
Re: 3D printed utility vehicle
Quote:
 https://youtu.be/x70-BsoIpks
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
