Hydraulik pressure sensor

[malawicarsten]

Hi

Does anyone know of a small 5V hydraulic pressure sensor ?

Of cause if it will fit the M3 thread in a Wedico 966g it's super good

It's ok if analoge voltage out as I can use analog input on my Frsky telemetry receiver to set Warning on my Frsky X9E

Thanks

Carsten

[ddmckee54]

Found one on Amazon that's available up to 1000 psi, I Googled "pressure transducer arduino" and got a boat-load of hits. I'm not going to try posting the link, it's seems like it's over a mile long. You'll have to make your own adapter because I don't think anybody makes one in an M3 thread.

Don

[malawicarsten]

Hi

Like these sensors?
https://www.amazon.co.uk/s?k=pressur...ref=aw_s_fkmr0

None of them are even near M5 thread sadly :/