my tools "98" Mazak

[tc1cat]

Nice purchase! Looks right at home with your lathe. Old and heavy rather than new and light weight!! If you can afford a Kurt angle-loc vise, get it! They are the best you can get! Hopefully, the mill uses R-8 tooling. Lots of things out there for it if so. You make me green also as I have no room for anything that big

Lynn

Sherline CNC is still waiting for new parts Budget ran out of funding at the moment.

[ihbuilder]

Originally Posted by Vanisle

Ummm, that's just a little bigger than your Taig mill. Hopefully you can make the adjustment to using it. I wish I had your room for machinery.

Is this the machine that is going to turn out all of your new wheels? If so, will you turn the OD of the wheel blank on the lathe and then finish it off in the mill? Looks like fun.

Rich , I out grew that tiag the minute i set it up I should have stuck with my gut instinct well I had to unload some stuff to get this size . but it is worth it the only part of the wheel process being done on here is holes and taping I'm now looking to get a cnc tool room lathe next that will take the bar size I use . I got a 150 wheels @ the drill press right now and only finished drilling the hubs . At the amount I'm doing it's getting old doing it by hand . once the mill is going , I'll be making stuff I've been trying to get to for a while .

Originally Posted by tc1cat

Nice purchase! Looks right at home with your lathe. Old and heavy rather than new and light weight!! If you can afford a Kurt angle-loc vise, get it! They are the best you can get! Hopefully, the mill uses R-8 tooling. Lots of things out there for it if so. You make me green also as I have no room for anything that big

Lynn

Sherline CNC is still waiting for new parts Budget ran out of funding at the moment.

that stinks with the sherline ,Lynn I know what you mean with budget this 1 is slightly over budget but It just finished a job before I picked it up . It takes a # 40 tool holder . the space comes from being in the excavating bizz ,need a big shop to work on stuff although I never got mine built and prob. wont need to either . just listed another piece this morn.. hate to see it go but not doing any good sittin here .

[Blender]

Originally Posted by tc1cat

Sherline CNC is still waiting for new parts Budget ran out of funding at the moment.

what parts do you still need? I finished my sherline conversion for pretty cheap.

[tc1cat]

Size #40 tool holders!! That is huge for a manual machine. I still need 2 new stepper motors. Sherline has smaller stepper motors and wrong type of connectors on it right now.

Lynn

[ihbuilder]

Originally Posted by tc1cat

Size #40 tool holders!! That is huge for a manual machine. I still need 2 new stepper motors. Sherline has smaller stepper motors and wrong type of connectors on it right now.

Lynn

Lynn it's a cnc mill still need the lathe yet then I'm set

[tc1cat]

I know that it is CNC just that size toolholders are huge for most single tool machines. That thing should be able to handle some heavy duty milling! I think that the Okuma CNC mills I have been running use the same size. Only ran one other CNC mill that used bigger toolholders. It was a beast!!
Are the controls on your new mill Fanuc or something else?

Lynn

[ihbuilder]

well the big gray old POSCNC mill was giving me such a headache I had to put it aside till I can get a control for it and have time to work on it . BUT 2 new pieces came and I finally got them hooked up now I'm waiting for the rest of the tooling

8600# mill most expensive of the 2 got lucky on this 1


5000# 16/40 lathe it's not new but it's no antique and it is sweet