MORPOWER pump & valve

[ihbuilder]

I would put better servos on these I had some finicky 1s . A hiteck 85MG fits

[RCP57]

Have you used the valves yet Steve? Opinions????

[ihbuilder]

Originally Posted by RCP57

Have you used the valves yet Steve? Opinions????

Yes in my compactor . I slightly modified them a bit . I bored the feed and return out to accept 5mm fittings also helps with the flow . I'm using the Jung pump with them turned down low ( it's more pump then needed but I had it ) the only issue was the servos seemed weak sometimes would not move or move partially . IMO , it's bulky for a small model but fits well with the Jung in the 825C ( just )