Fumotec 490

[Rakthi]

Congrats! You will enjoy assembling it!

The Li-Po I use for mine is 3S 5000mAh. Cont. 40C/Burst: 80C

It's 15.5cm (6 inches) by 4.5cm (1¾ inches) by 2.5 cm (1 inch) and just fits in the counterweight with some room left over for the wires.

[calum_scania]

Originally Posted by Rakthi

Congrats! You will enjoy assembling it!

The Li-Po I use for mine is 3S 5000mAh. Cont. 40C/Burst: 80C

It's 15.5cm (6 inches) by 4.5cm (1¾ inches) by 2.5 cm (1 inch) and just fits in the counterweight with some room left over for the wires.

So far so good!

Okay, I will have a look at that too. I plan on making a box/mount for it to sit in behind the valves if I have enough room

Regards Calum

[calum_scania]

Slow progress from the weekend but paint has showed up so after a first assemble I will strip it back down and hopefully paint and assemble the undercarriage





Premacon valves



Regards Calum

[D8R]

Nice model and will be a good runner I think.
This type of valve is under concideration for my rebuild now. Anyone that can get feedback how they perform.
What size of pump did you go for?

[calum_scania]

Originally Posted by D8R

Nice model and will be a good runner I think.
This type of valve is under concideration for my rebuild now. Anyone that can get feedback how they perform.
What size of pump did you go for?

Worked perfectly in my machine with the pump supplied by Fumotec, its exactly the same valves which he use in the 490 except made of steel instead