|
|
|
|
#1
04-24-2016, 10:05 PM
|
||||
|
||||
Re: Great Dane excavating co.
We take him to our river lot and he actually listens better than any dog, knows his boundaries and even gets in the river! Just throw a small stick and he comes running!! Yeah, for a cat, he's a keeper!! Even though I'm more of a dog person!!! But he is my shop companion
 . Ok starting on the part where fittings attach. Using a 5/16 shaft for the cylinder to attach to. That will run from one side to other. The 1/8" tube is for the top oil port. That will get welded in top and bottom of first stage. Once I figure out actual lengths of each stage and decide weather to have a bolted on end of last stage or have the final stage with bolt on seal cap. But I wanted to make the bottom where fittings attach able to slide in from top, that's why it's same diameter as first stage cylinder. It's still a bit confusing to me and still not sure what I m doing     
__________________
Always wasting money, as the wife says. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. 
|
|
#2
04-24-2016, 10:30 PM
|
||||
|
||||
|
Re: Great Dane excavating co.
looks good so far Coop . I'm assuming you got stainless rod for tig welding your joint .
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
 |
| Currently Active Users Viewing This Thread: 4 (0 members and 4 guests) | |
|
|
Hybrid Mode
