|
|
|
|
#1
10-02-2016, 08:34 AM
|
||||
|
||||
Re: Great Dane excavating co.
Can't wait to watch you build a ramp, and drive the dozer into the half filled truck for transport to the next job site!
On your piston design change, did you go from weld to a drilled cross hole with a pin? And then did you have to weld on the other end of the o ring cap? All these pictures makes me want to try machining something similar. Thanks for the photos! Jim 
|
 |
| Currently Active Users Viewing This Thread: 25 (0 members and 25 guests) | |
|
|
Hybrid Mode
