LilGiantsConstrCo

[Lil Giants]

Servo wire would be bout 24awg, right? Thanx for the tip Rob, and thanx for the link RW, RobotShop has a cdn outlet, looks to be cheaper & in cdn$ too... my HiTec charger came from here with free shipping.

http://www.robotshop.com/ca/en/catal...count&dir=desc

Styro board would be a good option for sure Jack, but I won't be there long.

Still a couple spots over 35 degree. And the B50 has no brakes either, it'll roll easily at just a few degrees, kind of a nuisance to park anywhere to load that isn't flat and/or soft.

The 1st time it happened with pulling 30+ then changing to probably low 20's, I was going maybe half throttle, the front end lifted almost high enough to flip the cab at the edge of a 3 foot cliff. I was right there to catch it, but to juggle radio & heavy model with no brakes Not a big deal to navigate now, just very low steady throttle & gotta be straight as possible, slightest bit of cab turn exaggerates the problem quickly.

Back when this thread started in 2005, I was hauling out of my basement with a Tamiya Mammoth climbing a narrow 16" wooden ramp @17 degrees. Trk half full, loaded front heavy would lift front left tire 1/4 inch, from the bottom all the way to top every time! Moved out 2,5 cu yd that summer... the next summer I put in a conveyer.

[oldguy70]

Joe

What did your HiTec charger cost you, and will it also discharge the batteries also what type of battery will it charge
Earl

[Lil Giants]

Originally Posted by oldguy70

Joe

What did your HiTec charger cost you, and will it also discharge the batteries also what type of battery will it charge
Earl

All questions answered in the link

http://www.robotshop.com/ca/en/x4-ac...MXeRoCB6vw_wcB