|
|
|
|
#1
04-27-2017, 05:10 PM
|
||||
|
||||
Re: LilGiantsConstrCo
Me too Mark... almost there
 Went to town early this morning to use a welding shop's hyd roller bender to curve 1" square tube   Over did the back side a lil bit    A couple of empty test runs with the 4206 & trl, a lil hairy going off the back side... some asphalt shingles might suffice. Just gotta wire up the crusher, but 1st I need a nap! 
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe 
|
|
#2
04-27-2017, 05:52 PM
|
||||
|
||||
|
Re: LilGiantsConstrCo
Quote:
 Looking forward to some clips of this beast in action.
__________________
Emil G | MFZ Blocher Fendt 926 | RC4WD Volvo EC480 excavator | Carson LR 634 | Kenworth 6x6 hauler | Kenworth 6x6 dtrk My channel: To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Construction site on Facebook: To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Pictures on Instagram: To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
 |
| Currently Active Users Viewing This Thread: 7 (0 members and 7 guests) | |
|
|
Hybrid Mode
