Bruder Conveyor Brass Rebuild

[frizzen]

That's looking awesome.

What's the plan for belt tracking adjustment?

[Highover]

Originally Posted by frizzen

That's looking awesome.

What's the plan for belt tracking adjustment?

No plan as of yet, im thinking of using the original rollers from the bruder frame, they have a grove in them that registers with teeth on the bottom of the belt.

[Rvjimd]

Here is a video link to your build. Do you think the 195 rpm is going to be about right? Were you able to measure the speed of the belt or just a guess? I ordered several motors last night in that range from a bit slower to faster. Thanks for the video!

For tracking i crown the rollers a bit, it doesn't take much, but with the center spline and original rollers you may not need to deal with it.

https://youtu.be/8DsMjBCIgkw

Jim

[Highover]

According to my math it should cycle a belt length every 4 or 6 seconds... but i can adjust that with the voltage. But it was mainly a guess... so heres hoping.

[Rvjimd]

Ya, I'm hoping I get something close with the new motors I ordered last night.

I am going to run a pulley or possibly chain and sprockets so I have a bit of adjusting I can do with the final ratio there to get the belt speed where it works good.

Jim