|
|
|||||||
| Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
03-27-2011, 10:18 AM
|
|||
|
|||
Re: RCMAN'S Mammoth build
im using a cheap futaba 2 channel. some times its a little touchy trying to get the bed up and down but i thinks that is because im using a standard servo i think it needs a heavy duty steering servo. what problems are you having with your radio?
Last edited by rcman; 03-27-2011 at 10:33 AM. 
|
|
#2
03-27-2011, 05:22 PM
|
||||
|
||||
|
Re: RCMAN'S Mammoth build
About the same as you. Drives OK but a real pain to get the bed up and down. Was told it is probably the radio not having enough amperage in the BEC circuitry to get the bed to go up and down reliably. I have tried 2 other new 2.4g radios but still no luck.
__________________
LYNN
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
