|
|
|||||||
| Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
03-27-2011, 08:08 PM
|
||||
|
||||
Re: Mack M75SX
Hope everything lines up ok in there Steve. That's definitely a strong setup if the pinion holds up. Do you have a link to the gears you are using?
|
|
#2
03-27-2011, 08:27 PM
|
||||
|
||||
|
Re: Mack M75SX
Steve , here's the pinion http://store.rc4wd.com/HPI-Racing-Be...1-_p_1377.html
the rest I got off ebay same as what I have in the pan only I made the axle housing for the truck . Here's a listing http://cgi.ebay.com/HPI-Savage-X-25-...item2eb3d51c69 Oh yes everything lines up  thank gawd  I didn't want to do it all over I still have to make the axle shafts . I may take the cups off the diffs and run the axle shaft right in . This what the cups look like http://cgi.ebay.com/HPI-86864-Differ...#ht_4874wt_872 they go into the spool and you slide a pin through the end then the bevel gear goes over top . mike , your looking at the rear axle components . axle housing done on the lathe thanks Clyde 
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Last edited by ihbuilder; 03-27-2011 at 08:35 PM.
|
|
| Currently Active Users Viewing This Thread: 3 (0 members and 3 guests) | |
|
|
Hybrid Mode
