Azonic Hitachi 470/Bell B50D

[modelman]

Good video-your models look good and seem to work really well. Nice job!

[Azonic]

Originally Posted by doodlebug

I've had trouble with my mechanical coupler getting jammed with mud.
I have a Cat 305C CR mini excavator.
Yes digging drain ditches can be a pain due to mud, packing everywhere!
Look's great so far!
Cheer's, Neil.

Yes i can understand that a mechanical coupler get stuck in the mud! I have operated a few different Volvo 140:s and they had hyd couplers and they got stuck as well sometimes when the bucket had sat to long in the coupler and rust and other effects made it stuck.

But some "shaking" with the bucket and some light pressing made it come loose at last.

Shouldnt be a problem on the scale coupler i hope!

Originally Posted by modelman

Good video-your models look good and seem to work really well. Nice job!

Thanks alot!


I also turned down 2 more comfortable stickgrips for my radio, turned out pretty good, im all new to machining parts, i wanted to make them a little concave where i hold my fingers, but i couldnt figure out how to make it concave on the manual lathe, very hard to turn it even over the whole part, any tips?

[elliot330]

Nice vid Kalle and nice canal as well. Its nice to dig with a purpose as well. Where was the Bell ?

[Azonic]

Originally Posted by elliot330

Nice vid Kalle and nice canal as well. Its nice to dig with a purpose as well. Where was the Bell ?

Thanks elliot!

I cant dig without a purpose, sure i can but i get bored after 5min, i have to do something that will be something, thats much more fun!

The Bell was in the background, there will be a cleaning up video from the same place where i did the trench, the Bell will take care of that!

[modelman]

Originally Posted by Azonic

Thanks alot!


I also turned down 2 more comfortable stickgrips for my radio, turned out pretty good, im all new to machining parts, i wanted to make them a little concave where i hold my fingers, but i couldnt figure out how to make it concave on the manual lathe, very hard to turn it even over the whole part, any tips?

I am also a "backyard machinist" and I probably would grind a tool to the shape I needed on the handles.

[Azonic]

Some operating the Hitachi and Bell was done this weekend.

Video!!
http://youtu.be/SjE0-2TVbF4









I also attended at a Truck show in Stockholm Sweden this weekend, a lot of fun!





















A bad little vid of the Hitachi getting towed..
[IMG][/IMG]

[elliot330]

Kalle, some really nice photos and video... that little tree put up a good fight as well.