S&M Trucking has a new loader!

[dabears]

Well with heat issues if any arise would you be able to take a small pc or hobby fan and run it to help cool down the electronics? like this one? http://www.ebay.com/itm/HOBBYWING-RC...item3f21eee013
I would think with a few cuts on the outside and the fan could bring air in or out to help keep it cool?

[Supermario]

Originally Posted by dabears

Well with heat issues if any arise would you be able to take a small pc or hobby fan and run it to help cool down the electronics? like this one? http://www.ebay.com/itm/HOBBYWING-RC...item3f21eee013
I would think with a few cuts on the outside and the fan could bring air in or out to help keep it cool?

Thanks Aaron. You might be onto something with that fan. By the looks of the dimensions 30mmX 30mm. It would fit. The location of motor n pump is near the rear axle , I think I could drill a bunch of holes under the rear fender behind the steps on each side so the fan could move the air through and you wouldn't even see the holes.

[Dunga_CZE]

Originally Posted by dabears

Well with heat issues if any arise would you be able to take a small pc or hobby fan and run it to help cool down the electronics? like this one? http://www.ebay.com/itm/HOBBYWING-RC...item3f21eee013
I would think with a few cuts on the outside and the fan could bring air in or out to help keep it cool?

In case of using such a fan you can use this one for less than half bucks
http://www.ebay.com/itm/Brushless-DC...item3a7c63eabe