|
|
|||||||
| Die-Cast Conversions Tech. The tricks of installing drive line and electrical components into die-cast models. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
09-08-2013, 01:39 PM
|
||||
|
||||
Re: He is at it again! 1:50 Dozer Conversion
Looks like it works great, seems to be smooth but sounds like gears jumping towards the end, or is that just normal track noise? Anyway nice job!
|
|
#2
09-09-2013, 08:00 AM
|
||||
|
||||
|
Re: He is at it again! 1:50 Dozer Conversion
Truck maker,
That was probably the pinion slipping on the plastic crown gear. I'm in the middle of yet another version. I'm making the rear end of the chassis out of aluminum angle stock so I can position the two drive motors where I want them and I'm using two steel pinions instead of one steel and one plastic crown. Film at eleven!  Jim
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
