stretched scania with wedico tanker project

[chris1210]

Originally Posted by bigdogrod

see if you can pick out which tamiya parts are in there... lol

LoL, it's 4 air horns that you used to build the valves, I need two of those for my King Hauler

[bigdogrod]

you are correct sir

but you only get partial credit, there's 3 other stock tamiya parts in each valve assembly..

[fhhhstix]

Originally Posted by bigdogrod

you are correct sir

but you only get partial credit, there's 3 other stock tamiya parts in each valve assembly..

Turn signals and air breather top mount.

[bigdogrod]

very good, give the man a beer

but still 1 more part in there...

screws don't count

[bigdogrod]

ok, found a way to get another cab, buy a whole truck.. lol, i think i need to take a bit more off. i measured the tamiya wheel and scaled the real pic to match, then measured from the cab door to the end, and cut. but these 2 comparison pics don't seem to match real well

[bigdogrod]

cut about 3/4 inch off the cab, looks better now. i read that the builders added 51 inches to the original, so 1/14 of that is about 3.5 inches, and that's about where i'm at. i may have messed up using the blue tamiya cab, i thought it was pretty much just blue plastic, but it has a clear coat on it, so i sanded off as much as i could. especially where the glue will sit. i'll give it a gentle wash in brake fluid before bodywork.