|
|
|||||||
| Metal forming & tools If it bends,twists,welds,cuts & turns metal.Post it here |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
12-15-2013, 11:24 PM
|
||||
|
||||
Re: my tools "98" Mazak
Steve, have you got that Mazak going yet?
I program and run a Mazak Quick Turn 250 MSY. 2 spindles, 12 tools, live tooling, Y-axis too. Mine is a little newer, from early 00's. Has the Nexus controller. Also run a 700D II 50 taper mill. Big sumbich. Thats an '06 machine with the Matrix controller. Do you plan on using any CAM programs or are you going to program at the controller? I was floored by how easy the programming was. I had never ran a Mazak a day in my life and was able to figure it out with little training. Good luck! 
|
|
#2
12-16-2013, 06:27 AM
|
||||
|
||||
|
Re: my tools "98" Mazak
I program at the control . Maztrol is so darn easy it threw me off at 1st cam for a 2 axis lathe just seemed like a waste . I may be looking into a vtc 16 in the near future
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
